96
Menu Description
Limitation Those functions are displayed which limit the inverter‘s output
values, such as active and reactive powers and AC output cur-
rent (output limitation).
Reactive power Those functions are displayed that have an impact on the reac-
tive power taken up or given off by the inverter (reactive power
control).
Reference parameters Display of nominal values and reference parameters.
External input
Function / arameter Description Unit / status
EISD Monitoring the "external shutdown" input at the I/O
module.
-
EISD-ENA EISD function status Disabled/enabled
EISD-SL "External shutdown" input logic High active /
low active
EPC Output control by radio ripple control receiver or
similar external control unit.
-
EPC-ENA EPC function status Disabled/enabled
SPIL Remote control using SPI logic (only available with
"Italy" country setting)
-
SPIL-ENA SPIL function status Disabled/enabled
SPIL-SESL Signal logic of input "Segnale Esterno" (Input "K6"
on I/O module)
High active /
low active
SPIL-CL Logic state of "Comando Locale" 0/1
SPILFM1 SPI frequency monitoring mode 1 -
SPILFM1-ENA SPILFM1 function status Disabled/enabled
SPILFM1-THRMIN Minimum permissible mains frequency, mode 1 Hz
SPILFM1-DLYMIN Tripping time s
SPILFM1-THRMAX Maximum permissible mains frequency, mode 1 Hz
SPILFM1-DLYMAX Tripping time s
SPILFM2 SPI frequency monitoring mode 2 -
SPILFM2-ENA SPILFM2 function status Disabled/enabled
SPILFM2-THRMIN Minimum permissible mains frequency, mode 2 Hz
SPILFM2-DLYMIN Tripping time s
SPILFM2-THRMAX Maximum permissible mains frequency, mode 2 Hz
SPILFM2-DLYMAX Tripping time s
SPILFM3 SPI frequency monitoring mode 3 -
SPILFM3-ENA SPILFM3 function status Disabled/enabled
SPILFM3-THRMIN Minimum permissible mains frequency, mode 3 Hz
SPILFM3-DLYMIN Tripping time s
SPILFM3-THRMAX Maximum permissible mains frequency, mode 3 Hz
To Next Page
Loading...
