126
Decommissioning
Step 6: Disconnect the battery connectors: Insert the flat-head screwdriver into the
notch of connectors and slightly pull the connectors.
Figure 13-3 Disconnecting the battery connector
Step 7: Disconnect the AC connector: Loosen the swivel nut and the four screws on the
AC protective cover; use flat-head screwdriver to loosen the screws on Grid and
EPS (off-grid) connection terminal. Slight pull the connectors.
M4
M5
Figure 13-4 Disconnecting the AC connector
WARNING!
• Before pulling the connectors, use multimeter to measure the AC voltage and make
sure the voltage is lower than 36 Vac.
Step 8: Disconnect the COM / BMS / Meter / CT cable: Loosen the waterproof
connectors and slight unplug the RJ45 terminal.
To Next Page
Loading...
