SolaX Power X3-Hybrid G4 Series - Page 135

127
Decommissioning
1
2
Figure 13-5 Disconnecting the COM / BMS / Meter / CT cable
Step 9: Disconnect the CAN1 / CAN2 / DRM / OFF cable: Loosen the swivel nut and four
crossscrews on the cover and slight unplug the RJ45 terminal.
1
1
2
2
2
2
3
3
3
3
Figure 13-6 Disconnecting the CAN1 / CAN2 / DRM / OFF cable
Step 10: Slight unplug the dongle module.
Step 11: Put the original teriminal caps on the terminals.
Step 12: Unscrew the grounding screw and remove the grounding cable.
Step 13: Unlock the anti-theft lock if you installed it. Unscrew the M5 screw on the side of
inverter and vertically lift up the inverter to dismantle the inverter.
Figure 13-7 Unscrewing the M5 screws
Step 14: Unscrew the screws for fastening the bracket and remove the bracket if needed.