1
Conventional PV modules and strings may be measured in parallel, up to the current
limit specified here. High-efficiency modules should NOT be measured in parallel.
2.
Automatically selected. Measurement sweep time depends upon the characteristics of
the test device (PV module, string, or array) electrical characteristics.
3
At ends of the primary test leads permanently attached to the I-V Measurement Unit.
SolSensor 200/300/300V2 Specifications
Table 5. SolSensor 200/300/300V2 specifications
Silicon photodiode with corrections for temperature,
spectral, and angular effects
Typically, ±2% when used to predict the
performance of well characterized poly- and
monocrystalline PV modules with direct irradiance
>600W/m
2
. Contact Solmetric Application
Engineering for more information on accurate
irradiance measurements.
0.1 s (Measurement bandwidth approximately
10 Hz)
Type K thermocouple. Two inputs.
Typically, less than 2C including inherent
thermocouple limitations and assuming SmartTemp
To Next Page
Loading...
Need help?
General
