1 Getting Started
2-43
Mounting SolSensor to a PV module frame
Below, Figure 21 shows SolSensor attached to a PV module with the Module Frame
Clamp and secured with the Tool Lanyard.
NOTE Mounting SolSensor along the upper horizontal edge of the module allows you to achieve
better irradiance accuracy earlier and later in the day.
Figure 21. SolSensor tool lanyard secured to a racking member.
To mount SolSensor, follow these steps:
1. Remove SolSensor, the Module Frame Clamp, and the tool lanyard from the soft
case.
2. Attach the tool lanyard to an eyelet on SolSensor. Then loop the lanyard around
a racking member and clip it back on itself, as shown in Figure 21.
3. Place SolSensor against the top horizontal leg of the module frame, with its
metal posts and ears seated against the frame surfaces, as shown in Figure 22.
To Next Page
Loading...
Need help?
General
