1 Getting Started
2-46
Figure 25. Locating the thermocouple tip on a single free-standing module.
9. Remove the protective cover from SolSensor irradiance sensor.
10. Press the button to turn SolSensor on, as shown in Figure 26. The LED will
blink on and off as it attempts a wireless connection, and will glow steadily
when the connection is made. The SolSensor 300xx links to the PVA-1500xx I-
V Unit, which relays its communications with the PC. Make sure the I-V Unit is
turned on. The original SolSensor links to the wireless USB adapter plugged
into your PC.
Figure 26. SolSensor pushbutton with LED lit. LED blinks until wireless
network is established, after which it remains on.
To Next Page
Loading...
Need help?
General
