MPI-536 – USER MANUAL
2.3 Communication
2.3.1 USB communication
The B-type USB port built-in in the meter is used to connect the meter to the computer in order to
download the data stored in its memory. The data may be downloaded and read through the software
provided by the manufacturer.
Sonel Reader – the software is used to retrieve the data saved from the meter memory. In
addition, it enables data transfer to the PC, data saving in popular formats and printing.
Sonel Reports PLUS – supports creation of documentation after testing of electrical instal-
lation. Software communicates with Sonel test instruments, download data from memory of
test instrument and creates necessary documentation.
Detailed information is available from the manufacturer and distributors.
Connect the cable to the USB port of the computer and the USB slot of the meter.
Current versions of software may be found at the manufacturer’s website in section
Download.
2.3.2 Connection to a Wi-Fi network
Go to Settings ► Communication settings ► Wi-Fi.
Turn on Wi-Fi (the Wi-Fi status icon should appear in the top bar).
Select a network with Internet access from the list. Touch it twice and - if it is password-
protected - enter the password. To log out of the network, also tap it twice.
Select Ok and check that the meter is connected to the network. The Wi-Fi status icon will then
indicate the signal strength.
2.3.3 E-mail settings
Go to Settings ► Communi-
cation settings ► E-mail set-
tings.
Fill the fields on the screen:
o parameters of the outbox,
o target mailbox address.
Press TEST to send a test
email.
The function works with selected email providers. The list of suppliers is available on the
manufacturer's website.
To Next Page
Loading...
Need help?
General
