– 22 –
5-8. AGING MODE
This unit is provided with an aging mode.
In this mode, MD and CD operations are performed alternately according to the following sequence.
Aging will be carried out continuously unless an error occurs.
If an error occurs, the status and number of cycles are displayed alternately, and operations stop. (Refer to Table 1.)
Aging Mode Sequence
NO
NO
YES
YES
OK?
NO
OK?
NO
NO
YES
OK?
OK?
NO
OK?
NO
OK?
NO
OK?
NO
YES
YES
YES
YES
YES
OK
YES
NG
Start
Turn ON Power using function MD
MD TOC READ
Cannot read
Message 6
Can read
MD all erase
Above 20
MD last track
Less than 20
Blank disc
Message 1
CD function is set and CD TOC is read
CD TOC OK?
Message 7
CD synchro standby
Message 2 or 8
CD last track search pause state
Message 9
CD synchro starts
Message 3 or 0
Synchro ends?
MD function is set
Playing CD?
CD tray opens
Message !¡
Message !º
CD tray closes
Message !™
MD last track (for 3 sec.) play
Message 4
Power goes off and MD TOC is written
Aging cycle number is displayed
Power turns ON and MD TOC is read
Message 5 or Message 6
To Next Page
Loading...
Need help?
General
