Menu List
183
Chapter 6 Menu Displays and Detailed Settings
a) The setting of this item is overridden by the setting of
Other BEFORE END when TYPE DETECTION in
the BATTERY 2 page is set to “OTHER”.
b) The setting of this item is overridden by the setting of
Other END when TYPE DETECTION in the
BATTERY 2 page is set to “OTHER”.
c) When TYPE DETECTION in the BATTERY 2 page
is set to “AUTO”, any batteries other than Sony BP-
series batteries and Anton Bauer intelligent battery
systems are classified as “Others”.
d) Flashes once per second when the battery status is
“BEFORE END”, and flashes 4 times per second
when the battery status is “END”.
e) A setting for this item is required when AU CH34
AGC MODE in the AUDIO-2 page is set to OFF.
f) A setting for this item is required when the DWR-
S01D Digital Wireless Receiver is installed.
g) SDI OUT 1 SELECT or SDI OUT 2 SELECT in the
OUTPUT 1 page of the OPERATION menu must be
set to HDSDI.
27 UP
CONVERTER
UP CON PROCESS FIELD/ADPT Selects the conversion source picture when
SD is upconverted to HD.
FIELD: Use the field picture.
ADPT: Optimize the ratio of conversion from
the frame or field picture.
UC DETAIL
LEVEL
(–99 to 99) Adjusts the sharpness of edge enhancement
by the upconverter.
UC CRISPENING (–8 to 7) Sets the amplitude width at which the
upconverter does not emphasize low-
amplitude signals.
UC DETAIL LIMIT (–99 to 99) Sets the maximum level of edge enhancement
by the upconverter.
UC LV DEPEND
LVL
(–8 to 7) Sets the luminance of edge enhancement by
the upconverter.
UC DTL
FREQUENCY
3.2M/4.5M/
5.0M/4.0M
Sets the center frequency and frequency
properties of edge enhancement by the
upconverter.
3.2M: 3.2 ± 1.1 MHz
4.5M: 4.5 ± 1.4 MHz
5.0M: 5.0 ± 0.7 MHz
4.0M: 4.0 ± 2.0 MHz
UC DTL H/V
RATIO
(–3 to 4) Sets the horizontal/vertical ratio of edge
enhancement by the upconverter.
28 CIS COMP FLICKER REDUCE OFF/ON/AUTO Sets whether to run the
flicker correction function.
FLICKER FREQ 50Hz/60Hz Sets the power supply
frequency of the lighting
causing the flicker.
No. Page Item Settings Description
FILE menu
No. Page Item Settings Description
01 USER FILE USER FILE LOAD EXEC For details, see “Saving and
Recalling User Files” on page
215.
USER FILE SAVE EXEC
F.ID Blank/up to 16
characters
USER PRESET EXEC For details, see “Resetting USER
menu settings to the standard
settings” on page 196.
To Next Page
