Advanced Operations for Shooting
97
Chapter 4 Shooting
To record with the Live Logging function
enabled
On the REC FUNCTION page of the
OPERATION menu, set LIVE LOGGING to one
of the following.
LIVE: Live mode
VIEW: Live view mode
Notes
• “LIVE LOGGING” does not appear in the REC
FUNCTION page of the OPERATION menu unless
the CBKZ-UPG01 Software Upgrade Key is installed.
• It is not possible to enable the Live Logging function
while this unit is in the following state.
- The proxy data recording function is enabled.
• It is not possible to set the Live Logging function to
Live View mode while this unit is in the following
states.
- The Picture Cache function is enabled.
- The Interval Rec function is enabled.
- The Disc Exchange Cache function is enabled.
- The Clip Continuous Rec function is enabled.
• The Live Logging function is disabled automatically
whenever you enable the proxy data recording
function.
You can connect a USB flash drive to the USB
connector and use it to save proxy data. (Here,
“proxy data” refers to proxy AV data for the clips
on the disc as well as to metadata.)
1)
You can then connect this USB flash drive to a
computer to view the recorded proxy AV data, to
edit and enter metadata (titles, comments, essence
marks, and so on), and to create clip lists.
1) When recording of proxy data finishes, the planning
metadata that has been loaded into this unit (if any) is
also copied to the USB flash drive. The data is saved
in the following directories, which are created
automatically when a USB flash drive is mounted.
• Proxy AV data: \MSSONY\PRO\XDCAM\
MEMDISC\PROAVID\Sub
• Metadata: \MSSONY\PRO\XDCAM\MEMDISC\
PROAVID\Clip
• Planning metadata: \MSSONY\PRO\XDCAM\
MEMDISC\PROAVID\General\Sony\Planning
Notes
• USB flash drives must be formatted with the FAT32
file system. If a drive is formatted with any other file
system, reformat it on this unit (see page 99).
• Never remove a USB flash drive or disconnect the
battery pack or power cord while it is being accessed
(while this unit’s ACCESS indicator is lit). Doing so
can corrupt the data on the USB flash drive and make
it unusable.
To enable proxy data recording and
copying to USB flash drives
Before starting, set ETHERNET/USB in the
POWER SAVE page of the OPERATION menu
to “ENABL”.
1 In the OPERATION menu, display the
MEMORY REC page.
See “Basic menu operations” (page 189) for
more information about menu operations.
2 Select MEMORY REC, and turn the
MENU knob until ENABL appears.
This enables proxy data recording and
copying from discs to USB flash drives.
Notes
• It is not possible to make proxy data recording settings
while this unit is in the following states.
- Wireless LAN connections are enabled.
• The Live Logging function is disabled automatically
whenever you enable the proxy data recording
function.
To record proxy data while synchronizing
with disc recording
1 Connect a USB flash drive to the USB
connector.
2 Check the memory symbol and the
memory remaining display (see page
30).
3 After confirming that the USB flash
drive has enough free capacity, press
the REC START button or the VTR
button on the lens to start recording as
normal.
1)
Recording proxy data
MEMORY REC : ENABL
COPY CURRENT CLP : EXEC
COPY ALL CLIPS : EXEC
ABORT COPY : EXEC
DEL ALL MEM CLP : EXEC
FORMAT MEMORY : EXEC
030 MEMORY REC TOP
To Next Page
Loading...
