To watch another TV program while recording
Set TV / DVD.VIDEO switch to DVD.VIDEO on the remote.
Press TV/VIDEO to display "TV" in the display window.
[
VIDEOI
I \1
I
If your TV is connected to the VCR using A/V connections, set the TV to the
TV's antenna input; if not, skip this step.
Select another channel on the TV.
To watch a DVD while recording
Press SELECT DVD to control the DVD player.
Press _--and place the disc on the disc tray.
Press 12:>PLAY.
The disc tray closes and the DVD player starts playback. The TV screen will
automatically change to the DVD playback screen.
To save a recording
To prevent accidental erasure, break
off the safety tab as illustrated. To
record on the tape again, cover the tab
hole with adhesive tape.
Safety ta_ I]
Tips
• To select a chmme], yotl c;in use the n/lmber buttons on tile remote commander. Enter the
channel number, then press ENTER.
• The display appears on tile TV screen indicating information about tile tape, but tile
information will not be recorded on the tape.
• If you do not want to watch TV while recording, you can turn off the TV. When using a cable
box. make sure to leax e it on.
Notes
• The remaining tape length may not be indicated accurately for short tapes such as T-20 or
%30. or tapes recorded in LP mode.
• It may take up to one minute for the VCR to calculate and display the remaining tape length
after you press DISPLAY.
• You cannot record a DVD directly to a VCR tape using your DVD-VCR.
• To watch a TV program during video recording, stop disc playback.
00
ca
{n
O
Recording TV programs 47us
To Next Page
Loading...
