Sony SLV-D271P - Page 55

Press _,/,*, to select an item.
SETUP Press SET UP to exit the menu.
o
Menu choices
• Dolby Digital
Selects the type of Dolby Digital signal.
The default setting is indicated in hold print.
D-PCM Select this when the player is connected to an audio component
lacking a built-in Dolby Digital decoder.
Dolby Digital Select this when the player is connected to an audio component
with a built-in Dolby Digital decoder.
• DTS
Selects whether or not to output DTS signals.
The defimlt setting is indicated in hold print.
Oil Select this when the player is connected to an audio component
lacking a built-in DTS decoder.
On Select this when the player is connected to an audio component
with a built-in DTS decoder.
• Audio DRC (Dynamic Range Control)
Makes the sound clear when the volume is turned down when playing a DVD that
conforms to "Audio DRC." This affects the outpnt from the following jacks:
- LINE OUT AUDIO L/R jacks
- DIGITAL AUDIO OUT (COAXIAL)jack only when "Dolby Digital" is set to
"D-PCM".
The default setting is indicated in hold print.
Standard Normally select this positon.
Wide Range Gives you the feeling of being at alive performance.
Notes
• If you connect a component that does not conform to the selected audio signal, a loud noise
lot no sound) will come out from the speakers, affecting your ears or causing the speakers to
be damaged.
• Noise may occur in the LinearPCM double-speed audio. This is not a malfunction.
tJ
-I
_t
-I
D.
&
e.-
3
Audio Setup 55 us