To cancel the setting
Select "Off' in step 2.
Notes
• When tile playing signal does not contain a signal lkn"tile rear speakers, the surround effects
will be difficult to hear.
• When you activate tile surround effect, turn off the surround setting of the connected TV or
amplifier (receiver).
• Make sure that your listening position is between and at an equal distance from your
speakers, and that the speakers are located in similar surroundings.
• If you use the DIGITAL AUDIO OUT (COAXIAL) jack and set "Dolby Digit:d" to "Dolby
Digital" or "DTS" to "On" in "AUDIO SETUP" menu (page 54), sound will come from your
speakers but it will not have the surround effect.
• Yuu cannot perlk_rm playback quickly or slowly with sound when a virtual surround effect is
set (page 37).
0
<
0
o
o
¢D
0
Virtual surround setting 77us
To Next Page
Loading...
