Sony XES - To Set the TIR Function

48 Listening to the Radio
Listening to the Radio
To Set the TIR Function
1 While listening to an FM broadcast, press MENU.
2 Select “RDS,” then press / to move to the
sub menu, then select “TIR Mode” using > or
..
CT on
TIR Mode
AF
on”
on
TA
on
Replay
off
set
on
Regional
on
RDS ”
R.Mode
Source
Exit
Set up
3 Press /, then > or . to select TIR mode item,
then ENTER.
Indication Operation
Replay Plays back the recorded TA.
on Turns the TIR function on.
off Turns the TIR function off.
set Sets the TIR preset time. (See below).
4 To set the preset time, select “set,” then ENTER.
TIR Set Timer1 8:00
BBC R1
_
+
1H
Timer2 17:00
_
+
1H
Press ENTER to select setting item (Timer1, Timer2, or
Station).
Press . or > to set the hour. Then press / to move
to minutes and press > or . to set the minutes.
For Station setting, press . or > to select the preset
station. While the cursor is on the station name
indication, press / or ? to tune to a station
manually.
5 After setting, press BACK.
Notes
• The system also
stands by for traffic
announcements for
two hours after you
turn off the engine,
as long as the TIR
function is on.
• If you have a power
aerial, it
automatically
extends every time
the system searches
for a traffic
programme station.
If you have a manual
aerial, make sure that
the aerial is fully
extended.
• If you do not use
your car for about a
week and the TIR
function is on, the
TIR function will
turn off
automatically to
prevent battery wear.