Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-142-
Sleep
Run
Set frequency curve:
Running frequency curve:
t1 < P01.20, the VFD does not run
t0=P01.34, sleep delay
Run
t2
t1
t0
Frequency lower
limit f0
Frequency f
Time t
Coast to
stop
t1+t2 ≥P01.20, the VFD runs
Setting range: 0.0–3600.0s (valid when the ones place of
P01.19 is 2)
This function code sets the automatic running of the VFD at
next power-on after power down.
0: Disabled restart
1: Enable restart, namely the VFD will run automatically
after the time set by P01.22 elapses if the starting
conditions are met.
Waiting time of
restart after
power cut
This function code sets the waiting time before
automatically running at next power-on after power down.
Output frequency
Running
Power off
Power on
Running
t
t1 t2
t1=P01.22
t2=P01.23
Setting range: 0.0–3600.0s (valid when P01.21 is 1)
This function code sets the delay of the VFD’s wake-up-
from-sleep after running command is given, the VFD will
start to run and output after the time set by P01.23 elapses
to realize brake release.
Setting range: 0.0–600.0s
Open-loop 0Hz
output selection
0: No voltage output
1: With voltage output
2: Output as per DC brake current of stop
Deceleration
time of
emergency-stop
Time of starting
section of
deceleration S
curve
To Next Page
Loading...
