Sourcetronic ST600 - Page 167

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-160-
58: Enable rigid tapping
59: Switches to V/F control
60: Switches to FVC control
61: PID polarity switch-over
62: Reserved
63: Enable servo
64: Limit of forward run
65: Limit of reverse run
66: Zero out encoder counting
67: Pulse increase
68: Enable pulse superimposition
69: Pulse decrease
70: Electronic gear selection
71: Switch to master
72: Switch to slave
73: Reset the roll diameter
74: Switch winding/unwinding
75: Pre-drive
76: Disable roll diameter calculation
77: Clear alarm display
78: Manual braking
79: Trigger forced feeding interrupt
80: Initial roll diameter 1
81: Initial roll diameter 2
82: Trigger fire mode control
83: Switch tension PID parameters
84–95: Reserved
P05.07
Reserved
/
/
/
P05.08
Polarity of input
terminal
This function code is used to set the polarity of input
terminals.
When the bit is set to 0, input terminal polarity is positive;
When the bit is set to 1, input terminal polarity is negative;
0x00–0x3F
0x00
○
P05.09
Digital filter time
Set S1–S4, filter time of HDI terminal sampling. In cases
where interference is strong, increase the value of this
parameter to avoid mal-operation.
0.000–1.000s
0.010s
○
P05.10
Virtual terminal
setting
0x00–0x3F (0: disable, 1: enable)
BIT0: S1 virtual terminal
BIT1: S2 virtual terminal
BIT2: S3 virtual terminal
BIT3: S4 virtual terminal
BIT4: HDIA virtual terminal
BIT5: HDIB virtual terminal
0x00
◎
P05.11
2/3 wire control
mode
This function code is used to set the 2/3 wire control mode.
0: 2-wire control 1; integrate enabling function with direction.
This mode is the most popular dual-line mode. Direction of
motor rotation is determined by the defined FWD/REV
0
◎