Sourcetronic ST600 - Page 173

Frequency Inverter ST600 Series High-Performance Multifunction VFD Function parameter list
-166-
32: Spindle scale-division completed
33: Speed limit reached in torque control
34: Virtual terminal output of
EtherCAT/PROFINET/EtherNet IP communication
35: Reserved
36: Speed/position control switch-over completed
37: Any frequency reached
38–40: Reserved
41: Y1 from the programmable card
42: Y2 from the programmable card
43: HDO from the programmable card
44: RO1 from the programmable card
45: RO2 from the programmable card
46: RO3 from the programmable card
47: RO4 from the programmable card
48: EC PT100 detected OH pre-alarm
49: EC PT1000 detected OH pre-alarm
50: AI/AO detected OH pre-alarm
51: Stopped or running at zero speed
52: Disconnection detected in tension control
53: Roll diameter setting reached
54: Max. roll diameter reached
55: Min. roll diameter reached
56: Fire control mode enabled
57–63: Reserved
P06.05
Output terminal
polarity selection
This function code is used to set the polarity of output
terminals.
When the bit is set to 0, input terminal polarity is
positive;
When the bit is set to 1 input terminal polarity is
negative.
BIT3
BIT2
BIT1
BIT0
RO2
RO1
HDO
Y
Setting range: 0x00–0x0F
0x00
○
P06.06
Y switch-on delay
This function code defines the corresponding delay of
the level variation from switch-on to switch-off.
Y electric level
Y valid
Invalid
Switch on
delay
invalid
Valid
Switch off
delay
Setting range: 0.000–50.000s
Note: P06.08 and P06.09 are valid only when
P06.00=1.
0.000s
○
P06.07
Y switch-off delay
0.000s
○
P06.08
HDO switch-on
delay
0.000s
○
P06.09
HDO switch-off
delay
0.000s
○
P06.10
Relay RO1 switch-
on delay
0.000s
○
P06.11
Relay RO1 switch-
off delay
0.000s
○
P06.12
Relay RO2 switch-
0.000s
○