Appendix G: Serial Port Commands
Serial Port Command Set
250 SmartBits System Reference
MACADDR To display the SmartBits MAC address. For information
only.
SERNUM To display the SmartBits serial number. For information
only.
ECHO ON To allow text entries via the serial port to be echoed
while entered. ECHO ON allows the user to see their
keystrokes as they occur. It is the default echo setting.
ECHO OFF To not allow text entries via the serial port to be
displayed while being entered. The ECHO state is
temporarily forced to ECHO OFF during all password
entry sessions.
BAUD [xxxxx] (SMB-200/2000 only) To set the baud rate to 9600,
19200, 38400, or 115200 for the serial connection.
SVBAUD [xxxxx] (SMB-200/2000 only) Changes the baud rate and saves
the new value to flash.
USERS Used with Multi-User chassis only (SMB-2000/600/
6000B), to display all users who are logged onto the
SmartBits chassis. For information only.
This command prints out a chart of all logged-on
Ethernet connections (users), their IP address, their TCP
port number, and a list of all cards each owns. The User
Number is the parameter used to close a user’s
connection. Example report:
Show Users detects 2 logged in users to report:
USER_NUM: IPADDR (TCP) PORT_NUM:
CARDS_OWNED:
1 192.168.103.50 1073 8
2 192.168.103.50 1074 9
Table G-1.Serial Port Command Set for SmartBits Chassis
Command Description
To Next Page
Loading...