Splicecom PCS 542 - Switch to Hands Free; Changing the Volume

Basic Call Handling
PCS 542 User Manual Version 3.3/0714/1
!19
!
!
Alternatively,
!
Please note that if you replace your handset while both calls are active you will connect the two calls
together.
!
Switch to Hands Free
You may wish to switch between hands free and handset operation without interrupting the call.
!
!
Please note:
•
If you press the Speaker button while using hands free you will end the call.
•
If your PCS 542 is configured so that your calls can only be handled hands free, when using a
headset in most cases, this feature is not available.
!
For further information please refer to the Hands free Operation section from page 1.
!
Changing the volume
You can change the ringing volume and conversation volume at any time during or before a call.
!
Changing the Volume before a call
Hands free volume
!
Handset volume
!
Changing the Ringing Volume
!
1
If you do not wish to answer use the navigation keys to select Reject. The call will
be passed to your Forward on Busy number (if set) or passed to voicemail (if
enabled) or cancelled. (Please refer to your System Administrator for further
information on your Forward on Busy number.)
From handset to hands free – press the Speaker button and replace the handset.
From hands free to handset – lift the handset.
1
Press the Speaker button.
2
Press the Volume Up or Down buttons as required.
3
Press the Speaker button when finished.
1
Lift your handset.
2
Press the Volume Up or Down buttons as required.
3
Replace the handset when finished.
While an incoming call is ringing, press the Volume Up or Down buttons as
required. The ringing volume will increase or decrease.
!
PCS 542 User Manual