SPM A2011 - Table of Contents

21
Technical data are subject to change without notice.
ISO 9001 certified. © Copyright SPM 1996-9. 71416.B
SPM Instrument AB • Box 4 • S-645 21 Strängnäs • Sweden
Tel +46 152 22500 • Fax +46 152 15075 • info@spminstrument.se • www.spminstrument.se
Part 2
Operating Instructions for
Shock Pulse Analyzer A2011
Contents
General functions
Transducers and probes ................................................................... 22
Instrument setup .............................................................................. 22
Instrument on/off ............................................................................. 22
Data Logging Mode
Measuring modes ............................................................................. 23
Measuring sequence, SPM ............................................................... 24
Measuring sequence, VIB ................................................................. 25
Speed measurement in Data logging mode .................................... 26
Manual Mode, Shock Pulse Measurement
Setting bearing data......................................................................... 27
Obtaining the basic bearing data .................................................... 28
TYPE Number table .......................................................................... 29
Taking shock pulse readings ............................................................ 30
Measuring point calibration ............................................................. 31
Error codes ....................................................................................... 32
The earphone.................................................................................... 33
Shock pulse transducers ................................................................... 34
Manual Mode, Vibration Severity Measurement
Vibration reading .............................................................................. 35
Vibration transducer ......................................................................... 35
Manual Mode, Speed Measurement
Optical measurement of rotational speed ....................................... 36
Contact measurement of speed....................................................... 37
Instrument Maintenance
Changing batteries ........................................................................... 38
Master reset ..................................................................................... 38
Changing the probe tip sleeve......................................................... 38