TRANSMISSION AND BRAKE SYSTEM
6-17
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
GEAR SELECTOR LEVER POSITIONS
P: PARK POSITION
Use this position to park your vehicle, start the engine, warm
up the engine, or stay in a location for an extended length
of time.
To shift into any other position, depress the brake pedal with
the ignition switch in the "ON" position.
• Never shift into “P” when the vehicle is moving, or the trans-
mission will be damaged. Stop the vehicle completely before shift-
ing into
“P”.
• To shift from the “P” position to another position, the ignition
switch must be turned to the “ON” position and the brake pedal
should be depressed. Any forcible attempts to move the selec-
tor lever from
“P” without the two procedures may damage
the selector lever and transmission.
WARNING
To shift from the “P”, the ignition switch must be turned to
ON and the brake pedal must be depressed. If you cannot
shift out of “P” with the ignition switch in ON, and the brake
pedal depressed:
1. Turn the ignition off and apply the parking brake.
2. Push down the shift lock release button hole with a stick
such as a pen. Then, shift the lever to the "N" position.
3. Start the engine, release the parking brake and shift the
lever to the "D" position to drive off.
If the selector lever is locked in the "P" position, release it by follow-
ing the above instructions and have your vehicle serviced by the
nearest Ssangyong dealer or Ssangyong Authorized Service Center.
WARNING
Shift lever lock
release
D146_06-Transmission and Brake System.p65 2009-12-30, ¿ÀÀü 3:21Page 17 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
