SEATS
7-6
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
POSITION MEMORY SETTING*
To Store the Memory Settings
1. Position the transmission shift lever to “P” with the
ignition switch “ON” (for your safety, do not start the
engine). In case of a manual transmission vehicle, you
must apply the parking brake too.
2. Adjust the driver’s seat and outside rearview mirrors to
the desired positions.
3. Press the (SET) switch. The indicator on the switch
comes on.
4. Within 5 seconds, press one of the position buttons
(
), ( ), ( ) you want to set. When the
memory setting is completed, a buzzer sounds twice.
SET button
STOP button
Position button
(1, 2, 3)
To Recall the Memory Settings
1. Press and hold one of the position buttons ( ),
(
), ( ) you want until the buzzer sounds.
2. The driver’s seat and outside rear view mirrors start
to move to the stored positions. If you drive off during
this recalling process, this automatic memory setting
stops operating.
3. Wait until they stop moving.
4. When the process is completed, a buzzer sounds twice.
The position memory is available for up to three drivers. Each driver can set his/ her own
driver’s seat, outside rearview mirrors. The information will individually be stored in the
integrated computer. If somebody has moved the seat, the memory positions can be
recalled automatically by pressing the position button.
D146_07-Seats.p65 2009-12-30, ¿ÀÀü 3:22Page 6 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
