INTERIOR SWITCHES
4-26
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
4WD LOW Indicator
When shifting the driving mode to “4L”, this
indicator blinks until the shifting operation
is completed. After completion of the mode
change to 4L, the indicator comes on. Af-
ter completion of the mode change to 4WD
HIGH, the indicator goes out.
4WD CHECK Warning Indicator
This warning indicator comes on when the
ignition switch is turned to “ON” and should
go out if the system is normal. If the “4WD
CHECK” warning indicator stays on, have
the 4WD system checked by the nearest
Ssangyong Authorized Service Center.
4WD HIGH Indicator
• When shifting the driving mode from “2H”
to “4H”, this indicator comes on.
• When shifting the driving mode from “4L”
to “4H”, this indicator blinks until the shift-
ing operation is completed. After comple-
tion of the mode change to 4H, the indi-
cator comes on.
WARNING LIGHTS/INDICATORS AND CAUTIONS WHEN USING 4-WHEEL DRIVE MODE
CAUTIONS WHEN USING 4-WHEEL
DRIVE MODE
• There could be mechanical noises and shocks during mode
changes. However, these are normal conditions due to the mode
changing operations.
• Use only the 2H mode on a normal paved surface. Do not drive
your vehicle in the “4H” or “4L” position on paved road surfaces.
Doing so will result in damages to the drive train.
• Driving in a 4 wheel mode on a normal paved surface will cause
unwanted noises, premature wear of tires, or increased fuel
consumption.
• To shift from “4L” into another mode or vice versa, stop the ve-
hicle and depress the brake pedal before any shift.
• If the “4WD CHECK” warning light stays on, have the 4WD sys-
tem checked by the nearest Ssangyong Dealer or Ssangyong
Authorized Service Center.
• When cornering a curved road in a 4-wheel drive mode (4L or
4H), there could be some mechanical shocks and resistances in
vehicle’s drive train. These are normal conditions due to internal
resistance in the drive train when the 4-wheel drive mode is
properly working. To avoid damages to the drive train, do not
drive your vehicle at an excessively high speed on a sharply
curved road.
• When shifting from “4L” to “4H” in an vehicle equipped with au-
tomatic transmission, move the gear selector lever from “N” to
“R” position after pushing the 4WD switch, and then move it to
the “N” position again. This helps to make the mode changes
easily.
D146_04-Interior Switches.p65 2009-12-30, ¿ÀÀü 3:20Page 26 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
