Stihl TS 420 Instruction Manual

TS 410, TS 420
English
26
Preparing the machine
N Before fueling, clean the filler cap
and the area around it so that dirt
cannot fall into the tank
N Always position the machine so that
the filler cap is facing upwards
WARNING
Never use a tool to open the bayonet
filler cap. The cap can be damaged and
fuel may escape.
Opening the twist lock
N Press the filler cap down as far as
possible by hand, then turn it
counterclockwise (approx.1/8turn)
and remove
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system for fuel (special accessory).
Closing the filler cap
N Fit the cap and turn it until it
engages in the bayonet catch
N Press the cap down as far as
possible with your hand and turn it
clockwise (approx. 1/8of a turn)
until it engages properly
Checking the lock
N Grip the cap – the cap is closed
properly if it cannot be removed and
the markings (arrows) on the cap
and fuel tank are aligned
If the cap can be removed or the
markings do not align, close the cap
again – see sections "Closing the cap"
and "Checking the lock".
Changing the fuel pickup body every
year
N Drain the fuel tank
N Pull the fuel pickup body out of the
tank with a hook and disconnect it
from the hose
N Connect a new fuel pickup body to
the hose
N Return the fuel pickup body to the
tank
Fueling
1.
2.
370BA093 KN
370BA094 KN
1.
2.
370BA095 KN
370BA019 KN

Stihl TS 420 Specifications

General

Engine Power	4.4 bhp
Weight	21.2 lbs
Arbor Size	20 mm
Maximum Wheel Size	350 mm
Maximum Cutting Depth	125 mm
Displacement	66.7 cc (4.1 cu. in.)
Fuel Capacity	710 cc