TS 410, TS 420
English
3
When the machine is not in use, put it
down safely so that it does not endanger
anyone. The machine must be secured
against unauthorized access.
The user is responsible for accidents or
hazards to third parties or damage to
their property.
Hand over or lend the power tool only to
persons who are familiar with this model
and its handling – always give them the
instruction manual as well.
The use of noise-emitting machines may
be restricted to certain times by national
or local regulations.
The machine may only be operated by
people who are fit, in good physical
health and in good mental condition.
If you have any condition that might be
aggravated by strenuous work, check
with your doctor before operating a
power tool.
If you have a pacemaker: The ignition
system of this machine produces an
electromagnetic field of very low
intensity. An effect on individual
pacemaker types cannot be excluded
entirely. STIHL recommends that you
consult your doctor and the
manufacturer of your pacemaker in
order to avoid health hazards.
Never work with the machine while
under the influence of alcohol,
medication or drugs capable of impairing
your reaction speed.
Postpone the work if the weather is bad
(snow, ice, wind) – higher risk of
accidents!
The machine is designed only for cutting
as specified. It is not suitable for cutting
wood or wooden objects.
Asbestos dust is extremely toxic – the
machine must therefore never be used
to cut asbestos!
Do not use the machine for any other
purpose because of the increased risk of
accidents and damage to the machine.
Do not modify the machine – otherwise
safety may be compromised. STIHL
excludes all liability for personal injury
and damage to property caused by
using unauthorized attachments.
Only use abrasive wheels or
accessories which have been approved
by STIHL for this machine or which are
technically equivalent. If you have any
questions in this respect, consult a
servicing dealer. Only use high-quality
abrasive wheels and attachments.
Otherwise there may be a risk of
accidents or damage to the machine.
STIHL recommends the use of genuine
STIHL abrasive wheels and
accessories. These have been
optimized for the product and the user's
requirements.
Do not use a pressure washer to clean
the machine. The strong water jet can
damage parts of the machine.
Do not spray the machine with water.
Clothing and equipment
Wear proper protective clothing and
equipment.
When cutting steel, always wear clothing
made of barely flammable material (e.g.,
leather or cotton with flame-retardant
finish) – no man-made fibers – risk of fire
due to flying sparks!
Ensure that there are no flammable
deposits (chips, fuel, oil, etc.) on your
clothing.
Remove any clothes that could be
trapped by moving parts, such as a
scarf, tie or jewelry. Long hair must be
tied up and covered.
Never use circular saw
blades, carbide, rescue
or wood cutting attach
-
ments or saws of any
kind – these may cause
fatal injuries! Instead of
uniformly removing parti
-
cles as when cutting with
an abrasive wheel, the
teeth of a circular saw
blade may snag in the
material. This causes the
machine to react in a
highly aggressive manner
with uncontrolled and
extremely dangerous
kickback.
Clothing must be sturdy
and snug-fitting, but allow
complete freedom of
movement. Wear close-
fitting clothes such as a
boiler suit, not a loose
jacket
To Next Page
Loading...
