CAUTION
Risk of damage to the battery male connector!
If the battery male connector is disconnected while
the key switch is switched on (under load), an arc
will be produced. This can lead to erosion at the
contacts, which considerably shortens the service life
of the contacts.
– Switch off the key switch before disconnecting the
battery male connector.
– Do not disconnect the battery male connector
while the key switch is switched on, except in an
emergency.
– Disconnect the battery male connector.
CAUTION
Harnesses may damage the paintwork on the indus-
trial truck!
Harnesses may damage paintwork by pressing and
chafing on the surface of the industrial truck. Hard
or sharp-edged harnesses, such as wire ropes or
chains, can quickly damage the surface.
– Use edge protectors or similar protective
devices.
Hooking on the lifting straps:
●
The lifting points on the industrial truck are
marked with corresponding adhesive labels.
– Attach the harnesses to the crane lifting
eyes. Insert the safety devices for the lifting
eyes (1).
Adjust the length of the harnesses so that the
truck remains level and does not start swing-
ing when it is being lifted.
CAUTION
Incorrectly fitted harnesses may damage attachment
parts!
Pressure from the harnesses can damage or destroy
attachment parts when the industrial truck is lifted. If
attachment parts (lighting etc.) constitute an obstruc-
tion, they must be removed before loading. If you
have any questions about this, please contact your
authorised service centre.
– Secure harnesses in such a way that they do not
touch any attachment parts.
Operation
4
Transporting the truck
74 5091 801 1525EN-12/2022 - 06
To Next Page
Loading...