• If the LEDs are flashing amber, then the cot head end is not in position.
7. Press the up (↑) button on the PPoowweerr--LLOOAADD control panel (
Figure 50) to raise the lifting arms to the highest position.
NNoottee -- The cot legs do not retract.
FFiigguurree 4499 –– LLoocckk tthhee wwhheeeell ppiinnss iinnttoo ppoossiittiioonn FFiigguurree 5500 –– PPrreessss tthhee uupp bbuuttttoonn ttoo rraaiissee tthhee lliiffttiinngg
aarrmmss
8. Operator 1 (foot end): Grasp the cot frame at the foot end. Squeeze and hold the cot manual release.
9. Operator 2 (side): Grasp the base frame. After the foot end operator squeezes the cot manual release, retract the
undercarriage with one hand and stabilize the cot with your other hand.
10.Both operators: Push the cot into the vehicle patient compartment, until the lifting arms lower and the cot locks into
PPoowweerr--LLOOAADD.
11.Operator 1: Continue to squeeze and hold the cot manual release.
12.Make sure that the cot is locked into PPoowweerr--LLOOAADD by firmly pulling side to side on the foot end of the cot.
13.After the call, remove the cot from service to diagnose and repair the PPoowweerr--PPRROO cot.
NNoottee -- PPoowweerr--LLOOAADD automatically charges the SSMMRRTT Pak battery when the cot is locked into PPoowweerr--LLOOAADD in the
transport position (no cable or connectors required). The cot battery LED indicator momentarily flashes green to signify
that it is charging.
EN 48 6390-709-001 Rev AB.1
To Next Page
Loading...
