pg 30
Deco - tape saturation & doubletracker
STEP 2 SET MIDI CHANNEL (CONT.)
4 Press either footswitch to exit and store your MIDI Channel setting
and begin using Deco�
NOTE: A simple way to check that communication is working is to send CC
#10 with a value of 127 when the TAPE SATURATION footswitch is off� This
will turn the TAPE SATURATION footswitch LED on if MIDI is properly con-
nected and configured�
NOTE: If you are only sending data to Deco using the Strymon MIDI EXP
Cable, the MIDI OUT mode must be set to OFF� (See page 31 for details on
configuring the MIDI OUT Mode�)
NOTE: MIDI Channel assignment is not saved per Favorite setting or MIDI
preset�
To Next Page
Loading...
