pg 29
Deco - tape saturation & doubletracker
Configuring Deco to Use MIDI (cont.)
STEP 2 SET MIDI CHANNEL
3 Turn the SATURATION knob to set the MIDI communication channel�
The TAPE SATURATION ON LED indicates status� Your SATURATION
knob selections are as follows:
• Channel 1: GREEN (default)
• Channel 2: AMBER
• Channel 3: RED
• Channel 4-16: BLUE (set by next received MIDI Program Change
message, requires 1⁄4” MIDI connection)
Once the TAPE SATURATION ON LED turns BLUE, it will blink until
the pedal receives a MIDI Program Change message� Once a mes-
sage is received, the pedal will be set to the MIDI channel that car-
ried the message and exit the power-up mode to allow you to begin
using Deco�
To Next Page
Loading...
