1656 & 1657 Battery Element Tester Owner’s Manual
STS Instruments Page 56 of 88
8.4.3 OUTPUT Commands
Output commands control the test application and output voltage being applied to the unit
under test.
OUTPut
Command Syntax: OUTPut
<space><n>
Purpose: Applies test voltage to the unit under test.
Description: Applies output test voltage. The query format returns the state of the
output as either on (1) or off (0).
Parameter: 0 | 1
Query Format: OUTPut?
Returns: 0 | 1
OUTPut:COUNt
Command Syntax: OUTPut:COUNt
<space><n>
Purpose: Sets the number of test repetitions to be applied to the unit under test.
Tests will run at the test interval programmed. See OUTP:TINT
command.
Description: Applies output test voltage repeatedly at pre-set time interval. When
set to zero (0), testing is continuous testing until aborted by operator or
program.
Parameter: 0 - 999
Query Format: OUTPut:COUNt?
Returns: <NR1>
OUTPut:TINTerval
Command Syntax: OUTPut:TINTerval
<space><n>
Purpose: This setting determines the time delay between repeated applications
of the test voltage to the UUT.
Description: Sets test time interval in milliseconds. See section 5.5, page 34.
Parameter: 30 or 65 – 5000
Query Format: OUTPut:TINTerval?
Returns: <NR1>
To Next Page
Loading...
