Micro Series
Micro Series 1-25
Document generated:29.06.17
SW V1.1
TheJinglesectioninthePLAYViewalsoshowsallJinglebuttonsandaStop
button.
Starting
/Restarting a jingle Pressing a Jingle button triggers the following actions :
•stopsanycurrentlycurrentlyplayingJingle
•turnstheJinglePlayerchanneltoON
•StartsplaybackoftheassociatedJinglefilefrombegin
If PFL is active, the Jingle Player channel is set to OFF.
Stopping a jingle A currently playing jingle can be stopped by either turning the Jingle Player
Channel to OFF or pressing the STOP button in the Play View page.
Playback of a Jingle stops automatically at its end without any user action.
When playback is stopped, the Jingle Player Channel is automatically
switched to channel OFF.
Note 1 : If the Jingle Player Channel is set to ON, eventhough no Jingle is playing,
the Jingle Player Channel is On Air.
As in the GUI, there is no fader to this channel, the On Air state is simply
activated by the channel ON/OFF button.
Note 2 : There is a difference to Micro Series mixers with connected Micro Fader
modules. In the case of connected Micro Fader module, the Jingle Player
Channel can have a fader - which then also has an effect on the On Air state
of the Jingle Player Channel.
As there is only one single instance of a Jingle Player, it doensn’t make sense
to have a second channel to be fed by the source USB 1/2.
To Next Page
Loading...
Need help?
General
