Studer Micro Series - Setup Procedures; Network Configuration; Micro Fader Module Pairing

Micro Series
1-78 Micro Series
Document generated: 29.06.17
SW V1.1
3 SETUP
3.1 Setting up the Network
To configure all network settings, please go to the Settings page. There, on
the Network tab, you can configure the network settings to your work with
your network environment.
Please see in chapter 1.5 how the Micro Core can be used in a network, and
then in chapter 2.4 how the settings are configured.
3.2 Setting up the Micro Fader modules
To configure one or two Micro Fader modules that are to be used with the
Micro Core, please go to the Settings page. There, on the Desk Modules tab,
you see all available Micro Fader modules, and you can assign a range of
channel strips to one or two of them. This comfoguration process is called
“pairing”.
Please see in chapter 2.4 how these settings can be configured.
Micro Fader Web GUI If a browser is prompted to the standard IP address of a Micro Fader module
(10.10.2.2) - the settings page of the connected Micro Fader module is
shown.
In the page, the device settings can be changed and updated :
  •DHCPOn/Off
  •IPAddress
  •SubnetMask
  •Gateway
  •CloudID
  •NodeName
  •Port
Important : After changing any of the Micro Fader’s settings, first click on the Update
Settings button, and then on the Reboot Device button. Only after a reboot