Micro Series
Micro Series 1-51
Document generated:29.06.17
SW V1.1
The config page of the channels pan section holds control elements necesarry
to set the channels panning/balance :
[1]
[3]
[2]
Pan/Bal depending wether mono or stereo channels
[1] Pan/Bal On/Off Activates the panner when illuminated.
[2] Pan/Bal Positions the signal between the left and the right leg of all stereo busses it
is assigned to.
[3] Reset This button sets all values of this processing block to the default values.
To Next Page
Loading...
