Micro Series
1-80 Micro Series
Document generated: 29.06.17
SW V1.1
The selectable sources for the monitoring sections are the following :
CR MON LSP (L)
CR MON LSP (R)
CR MON LSP (M)
These are the outputs of the CR monitoring section that are meant for a direct
connection of an active loudspeaker. Normally, the left and right speakers
are wired individually. The two stereo signals are downmixed internally to a
mono output (on the source marked M). This source can be used if a single
mono speaker will be used as CR mon speaker.
CR MON DIRECT (L)
CR MON DIRECT (R)
CR MON DIRECT (M)
The sources above, named DIRECT, are providing the same signal as CR
MON LSP, but without level control. These are normally used to connect a
meter that measures the level of the currently selected CR source. Be careful
not to connect an active loudspeaker to such a DIRECT source, as the signal
is fullscale and no level control is possible.
DJ HP (L)
DJ HP (R)
DJ HP (M)
These are the outputs carrying the HP signal of the Control Room Monitoring.
DJ HP DIRECT (L)
DJ HP DIRECT (R)
DJ HP DIRECT (M)
The HP signal of the Control Room Monitoring is also available as DIRECT
signal that has no volume control. This could be used if fed to a remote HP
amplifier when the DJ is remotely operating the Micro Core.
GUEST HP (L)
GUEST HP (R)
GUEST HP (M)
The GUEST HP Monitoring section only has a volume controlled output.
When the outputs are assigned as desired, the Config pages of the monitoring
sections can be used for further configuration.
CR Monitoring Options page :
Monitoring Source Here the actual monitoring source is chosen.
Cut This button lets the operator manually cut the CR monitor.
To Next Page
Loading...
