SummaCut cutter User’s Manual
Contour Cutting 3-15
‘System Setup’ will appear on the LCD.
4. Press
.
‘Confidence’ will appear on the LCD.
5. Use
or to scroll through the menu until ‘OPOS Settings’ is reached, press
.
‘X Distance’ will appear on the LCD.
6. Press
or until ‘Sheet Mode’ appears on the LCD.
‘Sheet mode’ is visible on screen.
7. Press
to confirm.
The value of the chosen parameter will appear on the LCD.
8. Press
or to change the value to ‘ON’.
‘ON’ will appear on the LCD.
9. Press
to confirm.
An asterisk will appear before ON, indicating it is now the selected setting.
10. Press
twice to leave the menu.
11. Register the markers and cut the first contour as described in sections 3.3.5 and 3.3.6.
The cutter will stop after the first contour has been cut and come online again.
12. Raise the pinch rollers and manually remove the sheet.
13. Insert the next sheet into the cutter. Lower the pinch rollers.
To Next Page
Loading...
