Summa SummaCut D160SE

Need help?

Do you have a question about the Summa SummaCut D160SE and is the answer not in the manual?

Summary

SECTION 1

1 GENERAL INFORMATION

Overview of general information related to the SummaCut cutter, including introduction and specifications.

1.2 SPECIFICATIONS

Detailed technical specifications for the SummaCut cutters covering dimensions, media, tools, interface, performance, and more.

1.5 CUTTER COMPONENTS

Identification and description of the cutter's main components, including rear and front panel controls.

1.6 POWERING UP THE CUTTER

Procedures for safely powering on the SummaCut cutter, including grounding.

1.7 LOADING MEDIA

Detailed procedures for loading various types of media into the cutter, including pinch roller positioning.

1.8 INSTALLATION OF TOOLS

Guides for installing different tools like knives, pens, and pouncing tools into the cutter.

SECTION 2

2 OPERATION

Overview of the SummaCut cutter's operation and main functions.

2.1 THE CONTROL PANEL

Detailed explanation of the SummaCut control panel, its display, and keys.

2.2 COMMON MENU ITEMS

Explanation of frequently used menu items for cutter settings like velocity, pressure, and configuration.

2.3 SYSTEM SETUP

Parameters for initial installation, configuration, and troubleshooting.

2.4 SUMMA CUTTER CONTROL

Using the Summa Cutter Control software for adjusting cutter settings.

SECTION 3

3 CONTOUR CUTTING ON THE SUMMACUT SERIES

Procedures for performing contour cutting with the SummaCut using alignment methods.

3.1 INTRODUCTION

Introduction to accurate alignment methods for contour cutting.

3.4 PLACING THE CROSS-MARKS

Instructions for placing cross-marks for accurate alignment.

3.6 LOADING THE CUTTER AND SETTING THE PARAMETERS

Loading the printed design and setting alignment parameters for contour cutting.

3.7 REGISTRATING THE CROSS-MARKS

Procedure for registering the cross-marks with the cutter for precise contour cutting.

3.8 CUTTING THE CONTOUR

Final steps for cutting out the contour based on registered marks.

SECTION 4

4 GENERAL INFORMATION

General information regarding maintenance and cleaning of the SummaCut.

4.1 MAINTENANCE & CLEANING

Procedures for maintaining and cleaning the SummaCut cutter.

4.2 OPERATING VOLTAGE

Information about the cutter's operating voltage and fuse replacement.

SECTION 5

5 INTERFACE

Information on connecting the cutter to a host computer via different interfaces.

5.1 INTRODUCTION

Overview of signal connections for cutter-computer communication.

5.2 RS232 INTERFACE NOTES

Details and system setup for the RS-232C serial interface.

5.3 USB INTERFACE NOTES

Details and installation procedures for the USB interface.