SummaCut User’ s Manual
Operation 2-20
2.4 SUMMA CUTTER CONTROL
All the settings of the SummaCut can be changed with the control program Summa
Cutter Control.
This program will only communicate with the cutter if the cutter is ready (to be sure the
cutter is ready press the
key 3 times)
By clicking on the ‘Menu’ button in the main Summa Cutter Control window, all the
cutter’s settings can be changed.
Four different user configurations can be saved in the cutter’s memory. The selected
configuration number is marked at the bottom of the menu window. These four
configurations are maintained independently.
To Next Page
Loading...
