SummaCut User’ s Manual
Contour Cutting 3-9
3.6 LOADING THE CUTTER AND SETTING THE PARAMETERS
WARNING
KEEP FINGERS AND OTHER BODY PARTS AWAY FROM THE CUTTING
AREA. THERE ARE HAZARDOUS MOVING PARTS.
• Load the print out in the cutter as described in section 1. Make sure that the cross-
mark indicating the origin is situated at the front right.
• If you have selected the XY-adjustment method (see above), then open Summa
Cutter Control and select OPOS in the Configuration menu.
♦
Fill in the values for the marker distances and press OK:
X-axis point
Origin point Y-axis point
To Next Page
Loading...
