Summa SummaCut D160SE - Recut; Reset; User Configuration

SummaCut User’ s Manual
Operation 2-7
2.2.8 USER CONFIGURATION.
The USER CONFIG (uration) gives access to different submenus that allow you to
configure the cutter's operating parameters. It should be taken into account that access
to some of the submenus will be determined by the plotting language you are using.
Four different user configurations can be saved. These four USER CONFIG 1(->4)
menus are maintained independently.
 To select another configuration number, proceed as follows:
WARNING
KEEP FINGERS AND OTHER BODY PARTS AWAY FROM THE CUTTING
AREA. THERE ARE HAZARDOUS MOVING PARTS.
1. Power on the cutter.
2. Press the key.
3. Press the key until USER CONFIG is displayed.
4. After pressing , press the or jogging key until the desired
configuration number is displayed .
NOTE
Before altering any of the items in the USER CONFIG menu, make sure that you
have previously selected the right configuration number in the USER CONFIG 1(-
>4) menu.
Figure 2-2 and 2-3 shows the USER CONFIG menu parameters.
2.2.9 RESET
The RESET instruction performs a complete reset of the cutter. Press the
key to
execute a reset.
2.2.10 RECUT
The RECUT instruction recuts the last file sent to the cutter (provided that it fitted into
the buffer). Press the
key to execute the instruction.