SummaCut User’ s Manual
Contour Cutting 3-8
3.5 PRINT THE DESIGN
• Print the markers and the design with your printer.
• When printing on a roll, make sure that the orientation is as follows:
♦ Make sure that there is at least 1 cm, preferably 2cm margin (0.4”,
preferably 0.8”) on each side.
• When printing on sheets or cutting off your print from the roll, make sure that there is
a margin of at least 8 cm (3.15”) at the end of the sheet:
Origin point
X-axis point
Origin point
X-axis point
Y-axis point
Y-axis point
To Next Page
Loading...
