Summa SummaCut D160SE - 3 Contour Cutting on the Summacut Series; Introduction

SummaCut User’ s Manual
Contour Cutting 3-1
SECTION 3
3 CONTOUR CUTTING ON THE SUMMACUT SERIES
3.1 INTRODUCTION
The SummaCut cutters have accurate alignment methods to guarantee precise contour
cutting. Standard included are the manual alignment methods. The possibilities of the
Factory installed OPOS are explained in a different manual.
Depending on the selected alignment method, the cutters can counterbalance the
following irregularities:
1. ROTATED DESIGN
: If the printed design is not loaded straight into the unit, the
contour can be rotated equally to fit the printed graphic.