Summa SummaCut D160SE - Installation of a Pouncing Tool

SummaCut User’s Manual
General Information 1-27
1.8.3 INSTALLATION OF A POUNCING TOOL
The SummaCut can also be operated with a pouncing tool. After replacing the knife
with a pouncing tool and after putting the special strip on the cutting strip, the cutter
can be used as a pouncer.
 To install the pouncing tool, proceed as follows:
WARNING
KEEP FINGERS AND OTHER BODY PARTS AWAY FROM THE CUTTING
AREA. THERE ARE HAZARDOUS MOVING PARTS.
• Power up the cutter and load a piece of media in the cutter (See 1.7.).
• Press the
key until “SYSTEM TEST” is displayed on the LCD.
• Press the
key.
• Press the
key until “TOOL” is displayed on the LCD.
• Press the
key. The current tool is now displayed.
• Press the
or key until “POUNCER” is displayed on the LCD.
• Press the
key to confirm tool change.
• Press the
key twice to come in normal mode.
• The cutter will now ask to insert the pouncing tool, if that was not the former
tool. Press any key to confirm
• Analogous to 1.8.1., point 6, the pouncing pressure can be changed.