Summa SummaCut D160SE - Opos Sensor; Opos Settings

SummaCut User’ s Manual
Operation 2-19
2.3.26 OPOS SETTINGS
The CALIBRATION OPOS sub-menu is used to change the different OPOS
parameters with the control panel.
To change the parameters press the
key. Then use the or jogging
keys the go through the different parameters and change the values with the
or
jogging keys. The different OPOS parameters are explained in the special section
about OPOS.
2.3.27 OPOS SENSOR
This submenu is to test the reflection value of OPOS.