Summa SummaCut D160SE - Knife, Pen and Pouncing Tool

SummaCut User’s Manual
General Information 1-5
Vinyl Types
A wide range of vinyl types has been evaluated and tested on the SummaCut. When
using duly certified media, operation in accordance with the functional specifications of
the model is warranted. Summa should certify other media before use to ensure
performance in compliance with specifications.
Plotting Paper
Bond paper (120 g/m² recommended)
1.2.3 KNIFE, PEN AND POUNCING TOOL
The SummaCut are supplied with two standard knife blades (for vinyl media) and a
black fibre tip pen.
Knife
Medium Quantity
Standard knife standard, reflective &
fluorescent vinyl types
2 off
Knife for masking stencil masking stencil &
thick material
optional
Pen
Color Quantity
Fibre tip pen black 1 off
Pouncing tool
Paper Optional
TABLE 1-3:
SUMMACUT KNIVES, PENS AND POUNCING TOOLS
To order replacement knives, pens and/or pouncing tools, contact your local dealer,
quoting the part numbers listed in table 1-9.
The SummaCut-series will only perform according to specifications if a genuine
Summa knife, pen or pouncing tool is installed. Do not replace the standard knife, pen
or pouncing tool with products from other manufacturers.