SummaCut User’ s Manual
Contour Cutting 3-2
2. SKEWED DESIGN: If the X and Y-axes of the printed design are not perpendicular,
the contour can be skewed to fit the printed design.
3. INCORRECTLY SCALED DESIGN
: If the print size is different from the original
design in your software due to media expansion or shrinkage, or due to printing
inaccuracies, the contour can be scaled to fit the printed graphic.
NOTE: The scaling can only be adjusted by a few percent.
Any combination of the three above irregularities can be handled too.
The parameter SPECIAL_LOAD in the user configuration menu determines
which alignment method is used. Use SummaCutter Control to select the desired
alignment method:
To Next Page
Loading...
