Summa SummaCut D160SE - SECTION 2; 2 OPERATION

SummaCut User’s Manual
Table of contents TOC ii
SECTION 2..................................................................................................................1-1
2 OPERATION.....................................................................................................2-1
2.1 THE CONTROL PANEL...............................................................................2-1
2.1.1 THE LIQUID CRYSTAL DISPLAY ................................................................2-1
2.1.2 THE MENU KEY ..............................................................................2-2
2.1.3 THE EXIT KEY ................................................................................2-3
2.1.4 THE ENTER KEY ............................................................................2-3
2.1.5 THE TEST KEY ..............................................................................2-3
2.1.6 THE JOGGING KEYS ..............................................................2-3
2.2 COMMON MENU ITEMS..............................................................................2-4
2.2.1 VELOCITY.....................................................................................................2-4
2.2.2 TURBOCUT ..................................................................................................2-4
2.2.3 PEN PRESSURE ..........................................................................................2-4
2.2.4 KNIFE PRESSURE.......................................................................................2-5
2.2.5 KNIFE OFFSET.............................................................................................2-5
2.2.6 POUNCING PRESSURE ..............................................................................2-6
2.2.7 POUNCING GAP ..........................................................................................2-6
2.2.8 USER CONFIGURATION. ............................................................................2-7
2.2.9 RESET ..........................................................................................................2-7
2.2.10 RECUT..........................................................................................................2-7
2.2.11 LOAD.............................................................................................................2-8
2.2.12 ALIGN LOAD.................................................................................................2-8
2.2.13 SYSTEM SETUP...........................................................................................2-8
2.3 SYSTEM SETUP ..........................................................................................2-9
2.3.1 CONFIDENCE.............................................................................................2-10
2.3.2 DIN CUT......................................................................................................2-10
2.3.3 TOOL...........................................................................................................2-10
2.3.4 FLEX-CUT...................................................................................................2-11
2.3.5 PANELLING ................................................................................................2-12
2.3.6 OVERCUT...................................................................................................2-12
2.3.7 OPTICUT.....................................................................................................2-12
2.3.8 EMULATE ...................................................................................................2-13
2.3.9 USB CLASS ................................................................................................2-13
2.3.10 BAUD RATE................................................................................................2-14
2.3.11 PARITY .......................................................................................................2-14
2.3.12 RTS/DTR.....................................................................................................2-15
2.3.13 RS 232 TEST ..............................................................................................2-15
2.3.14 ALIGN MODE..............................................................................................2-15
2.3.15 AUTOLOAD.................................................................................................2-16
2.3.16 LANGUAGE ................................................................................................2-16
2.3.17 DEFAULT MENU ........................................................................................2-16