Summa SummaCut D160SE - SECTION 4; 4 GENERAL INFORMATION; SECTION 5; 5 INTERFACE

SummaCut User’s Manual
Table of contents TOC iv
SECTION 4..................................................................................................................3-1
4 GENERAL INFORMATION..............................................................................4-1
4.1 MAINTENANCE & CLEANING ....................................................................4-1
4.1.1 CLEANING THE DRIVE SYSTEM................................................................4-1
4.1.2 CLEANING THE SENSOR............................................................................4-2
4.2 OPERATING VOLTAGE ..............................................................................4-3
SECTION 5..................................................................................................................4-1
5 INTERFACE .....................................................................................................5-1
5.1 INTRODUCTION...........................................................................................5-1
5.2 RS232 INTERFACE NOTES ........................................................................5-1
5.2.1 SYSTEM SETUP...........................................................................................5-1
5.2.2 SERIAL INTERFACE CONNECTOR ON THE CUTTER..............................5-2
5.2.3 AVAILABLE SERIAL SIGNALS.....................................................................5-2
5.3 USB INTERFACE NOTES............................................................................5-3
5.3.1 USB SPECIFICATIONS................................................................................5-3
5.3.2 INSTALLING THE USB SOFTWARE UNDER WINDOWS...........................5-3
5.3.3 INSTALLING THE USB SOFTWARE FOR YOUR MACINTOSH.................5-4