Summa SummaCut D160SE - Page 8

SummaCut User’s Manual
Table of contents TOC v
LIST OF ILLUSTRATIONS .......................................................................................PAGE
1-1 SUMMACUT CUTTER, REAR VIEW .............................................................. 1-9
1-2 SUMMACUT CUTTER, FRONT VIEW.......................................................... 1-11
1-3 GROUND CONNECTION.............................................................................. 1-13
1-4 BLADE INSERTION....................................................................................... 1-15
1-5 BLADE LENGTH ADJUSTMENT .................................................................. 1-16
1-6 SETTING KNIFE DEPTH............................................................................... 1-16
1-7 KNIFE DEPTH TEST PATTERN ................................................................... 1-17
1-8 PINCH ROLLER LEVER................................................................................ 1-21
1-9 FEEDING ROLL MEDIA WITH USING FLANGES....................................... 1-22
1-10 FEEDING ROLL MEDIA WITHOUT USING FLANGES ............................... 1-22
1-11 PINCH ROLLER POSITIONING.................................................................... 1-23
2-1 SUMMACUT, CONTROL PANEL.................................................................... 2-1
2-2 SUMMACUT, MAIN MENU.............................................................................. 2-2
2-1 SUMMACUT, SYSTEM SETUP ...................................................................... 2-7
4-1 CLEANING OF THE FRICTION DRIVE SYSTEM........................................... 4-2
4-2 POWER ENTRY MODULE.............................................................................. 4-3
LIST OF TABLES......................................................................................................PAGE
1-1 SUMMACUT CUTTER SPECIFICATIONS...................................................... 1-4
1-2 SUMMACUT MEDIA SPECIFICATIONS......................................................... 1-4
1-3 SUMMACUT KNIVES, PENS AND POUNCING TOOLS................................ 1-5
1-4 SUMMACUT INTERFACE SPECIFICATIONS................................................ 1-6
1-5 SUMMACUT FIRMWARE................................................................................ 1-6
1-6 SUMMACUT PERFORMANCES..................................................................... 1-6
1-7 SUMMACUT ENVIRONMENTAL SPECIFICATIONS ..................................... 1-7
1-8 SUMMACUT ELECTRICAL SPECIFICATIONS.............................................. 1-7
1-9 SUMMACUT ACCESSORIES AND CONSUMABLES .................................... 1-8