Table of contents I
Table of Contents
1 Setup ............................................................................................................... 1-1
1.1 Unpacking the Cutter
.......................................................................................... 1-1
1.1.1 Removing the packaging from the cutter...................................................................... 1-1
1.1.2 Setting up the machine wi
th a stand ............................................................................... 1-2
1.1.3 Setting up the machine wi
thout a stand ........................................................................ 1-4
1.2 SummaCut Cutter Components ......................................................................... 1-5
1.2.1 The Cutter as viewed from
the front ................................................................................ 1-5
1.2.2 The Cutter as viewed from
the back ................................................................................ 1-7
1.3 Connecting the Cutter to the Mains ................................................................... 1-9
1.3.1 Grounding (“Earthing”) ......................................................................................................... 1-9
1.3.2 Operating voltage
................................................................................................................... 1-9
1.3.3 Powering-on
the cutter ..................................................................................................... 1-10
1.4 Connecting the
Cutter to a Computer ............................................................. 1-11
1.4.1 USB connection
.................................................................................................................... 1-11
1.4.1.1 Connecting the SummaCut cutter
to a PC using a USB cable .................... 1-11
1.4.1.2 Connecting the SummaCut cutter
to a Mac using a USB cable ................. 1-12
1.4.2 RS-232 Conn
ection .............................................................................................................. 1-13
1.5 Loading Media
................................................................................................... 1-14
1.5.1 Pinch roller positioning
..................................................................................................... 1-14
1.5.2 Loading media
...................................................................................................................... 1-15
1.5.3 Media load
procedure ........................................................................................................ 1-18
1.6
Tool Installation ................................................................................................ 1-20
1.6.1 Knife installation ................................................................................................................... 1-20
1.6.2 Pen installati
on ..................................................................................................................... 1-24
To Next Page
Loading...
