SummaCut cutter User’s Manual
Detailed Operation 4-14
4.3.27 Cal. OPOS
This test calibrates the physical distance between the OPOS sensor and the knife tip. It is
explained in section 3.2.1
4.3.28 OPOS Parameters
The OPOS settings sub-menu is used to change the different OPOS parameters with the
control panel. It is explained in section 3.3.5
One parameter is not explained: OPOS paneling.
OPOS Paneling
With this option, the markers can be read in panels. The OPOS sensor will read markers
according to panel size, instead off loading them all be.
OPOS Panels can be set to OFF or ON. When set to ON, then the sensor will load only 2
markers in X-direction when loading OPOS. Other markers will be read when unrolling
media. Must be used with internal or software paneling.
OPOS XY is not supported when using paneled OPOS.
4.3.29 OPOS Sensor
This submenu is to test the reflection value of OPOS. Press
for readout.
To Next Page
Loading...
